1. The loading and unloading of the panelizer must be carried out by professional loaders. During the entire loading and unloading process, the stability of the panelizer must be ensured, and safety protection measures must be taken to prevent damage to the wood panel joining machine or accidents to the loaders.
2. All loading and unloading tools and temporary safety devices must be removed immediately after loading and unloading.
Due to the long length of the panelizer, it must be disassembled and assembled on site during transportation.
The unloading method is determined by the actual situation of the user. The machine is heavy, slender, and heavy at one end. Therefore, the capacity of the tools used should be fully considered when unloading. When unloading the truck with a crane, attention should be paid to the position of the sling. Jigsaws may cause severe deformation and overturning, thereby damaging the machine. Other methods must also consider these issues to avoid damage to the panelizer and endanger personal safety. The wood is dried and aged through the panelizer, and the moisture content is strictly controlled. For wood used to produce solid wood panels or laminated wood, the drying benchmark must be strictly controlled to ensure that the moisture content in the entire pile of wood is uniform. This is the main factor to ensure that solid wood panelsor laminated wood will not warp and crack.

The drying of wood for solid wood boards or laminated wood must strictly control its final moisture content, while ensuring that the deviation of the moisture content of the wood throughout the kiln is controlled within the minimum range, that is, strictly control the drying benchmark. The stage of moisture content balance is after the wood is dried. After the wood is dried from the kiln, it must be placed in a dry shed for aging. The main purpose of aging is to further balance the moisture content in the wood. During the wood drying process, the moisture content of the upper and lower parts, the inside and outside, and the inside and outside of each piece of wood is different. Appropriate time aging can make the moisture content of the wood more consistent. The second is to release the pressure in the wood. During the drying process of the wood, the change in moisture causes the size and volume of the wood to change in all directions, which produces internal stress on the wood. Keeping the wood for a certain period of time can effectively reduce internal stress. When the wood is dried and used to produce solid wood products, especially furniture, the aging time should be no less than 1 month.
Next, the editor will give you a manufacturer with a super good reputation, Hongfeng Machinery's high-frequency splicing machine, splicing machine, one person can operate a production line, easy to operate, uniform heating, and rapid shaping, it is definitely your best choice!